A simple game with a charming design. Balancing Twigs teaches physics, perseverance and playful competition. 3D print trunk and twigs on two or three printplates, then get stacking.
Players can take turns balancing their branches on the tree until it topples. Or you can play against an hourglass, trying to get all the branches balanced before the time runs out. Express your creativity with color combinations from nature—or your wildest imagination.
Please check if the size of the model you downloaded is the correct size as I had posted it and saw it was very small. I fixed the size. Sorry about any inconvenience.
Note: I did not design this model
Special thanks to Matthijs Kok:
https://www.behance.net/matthijskok
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.1 - 0.2
Infill:
40% - 100%
Notes:
I recommend using 40%+ infill on the trunk and 100% infill on the branches.
