A cute, little Stitch sculpt I made from the Disney Cartoon 'Lilo & Stitch'. This is not a re-topologized mesh - It is the original sculpt. The mesh is therefore very dense and highly detailed.
I recommend using a brim when printing the model. You might also need to resize the model since I messed up the units when I exported the model from Blender.
p.s.
I am still a 3D printing newb and my printer was very cheap, so the print quality of the print I did was not great, but I hope you and your printer can do better. :)
Printer:
Anycubic Kossel Mini
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
100 Microns
Infill:
20%
Notes:
Parts of the support structure inside the mouth were quite difficult to remove. Lowering the support density or Z distance might make the support removal less painful.
