All credit to lewj for the original. I couldn't have done it...I just re-mixed it.
Great piece lewj, love it! :)
Ok, here's what I did:
Made it 10% bigger.
Put the "B3" designation up front on barrel_1
Beefed up the grip so it fills the hand better
Dropped the rear part of "details_1" and made the front part bigger
Filled the gap above the trigger so there is no hole going through the middle
Added an (optional) barrel tip. (USA has a law that any toy gun MUST have an orange tip,,,print it in orange or paint it orange if you care about this). If you don't want/like it, leave it off.
Added a boat-load of detail using this as my reference piece:
https://www.artstation.com/artwork/Zzdam
Printer:
Anet A8 prusa clone
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
20%
Notes:
I've put Supports - Yes, but not necessary for all the pieces.
I havent printed one yet...i'm out of filament. But have run the pieces through Netfabb, and they slice ok in Cura, so....
Enjoy. :)
