T-38 Talon, by request of @dz1sfb
Is in 1/54 scale, it should be a easy print, very similar to the F5 Tiger.
Greetings, happy printing!
Printer:
Prusa i3 HIC
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
30%
Notes:
Is an easy print, i would recommend slow print speed to get a nice finish on the wings.
Sanding
A lot of sanding is needed, first use a dry pen or something with a sharp point to make the grooves deeper if needed, after this use a rough sanding paper, 80, to remove the printing lines, after use a 240 sanding paper to get good results, you can finish with 500 sanding paper to get a perfect finish.
I use acrylic paint on the F5 model, i think it looks good (I am not very good at painting), if you have recommendations on painting this model it will be much appreciated.
Greetings!
