Reindeer (with giraffe features) modelled in MeshMixer from a Cape Town style wire animal.
Made it that it can be printed as is,
with pads on the feet to stick more to the printing bed - if you dont like it - cut it off afterwards
should not require further support for ears, head or antlers
remove the tail support afterwards
I printed in PLA, with part cooling, and sufficient retraction to prevent stringiness around the antlers
Rafts:
No
Resolution:
0.3mm
Infill:
15%
Notes:
should print without further support. But you can add if you prefer
remove tail support
cut the feet pads smaller if you dont like it
