This is a model of a wren perched on a tree stump.
Print Settings
Printer brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
20
Filament brand:
Multicomp
Filament color:
White
Filament material:
PLA
Notes:
I scaled the model in Cura to a height of 9cm, which made it a nice size to paint and display.
There are overhangs on the body of the bird, bill and tree branches. However, I was able to successfully print the wren without and supports, leaving just a bit of post print cleaning up. Depending on your printer and filament, you may need to use supports.
Post-Printing
Because I didn't use supports where there were overhangs, there were a few stray loops of filament which I was able to easily clean off with a scalpel. I think it resulted in less work than cleaning up supports but you may have different experience with your printer and filament.
I've included some renders to give ideas for anyone who wants to paint the model. I've also included my attempt at painting, which I'm not yet happy with and will keep trying to mix better colours!
