by pixeltheory

This is a remix of the detailed toga figure better suited for 3D printing. The figure is split into two parts with a square register that is used to join them together.

I've included cura files, stls, and the blender file that I used to clean up the model (to make it manifold) and modify it and split it up. I also removed some of the hair strands that made it too difficult to print due to all of the on-model supports that were required.

Pretty satisfied with the overall print compared to the original.

NOTE: the full STL files are in the files.7z, 3MF files in the Ready2Print.7z

Print Settings

Printer brand:

Creality

Printer:

Ender 3

Rafts:

Yes

Supports:

Yes

Resolution:

0.2mm

Filament brand:

Inland

Filament color:

White

Filament material:

PLA

Notes:

I've included the blender file that i used to split up the model for printing. It's recommended to print each section separately using supports. I used normal supports instead of tree supports since they were much easier to clean up. I've also included my cura files (3mf) as well that should have the full profile settings for an ideal print.

Recommend using horizontal expantion set to 0.2mm for best results for some of the finer details of the model such as the strands of hair and wires.