Easy to print Maus, 1/100 scale, will want some greebling if scaled up. Some details have been changed for looks/ printability. There is quite a bit of in-built support material under the guns so look closely at the files and make sure to get rid of it all, there is a cross support between the guns, so don't cut that off. The center bottom piece is almost symmetric, but there is a small drive hump towards the rear. The treads are a shallower slope at the front. The turret has a notch on the bottom to locate the ring, and the ring glues on short edge towards the back. The fuel tank goes on with the center filler-cap up.
Scale by 1.56 for gaslands / hotwheels / 1/64
Scale by 1.786 for 28mm / 1/56
