by LeighLOSTfan
The JMC Red Dwarf
huge fan of the series wanted to make my own version of the original ship may add the different rear section (circle type with multiple engines) in the future made a few modification since my print let me know if it doesn't fit properly so it can be adjusted.
my print was separate so not sure how the combined full ship would print may work in 3 parts?
sides panels are all the same so you can mix and match whatever sides you want
added a few photos so you can see how the rear brace and internal braces work,
used spare 1.75 filament between the front scoop braces and as extra pipe work as you can see
total ship length is 44cm if printed at 100%
I printed most with a .2 layer size and 10% infill on most parts to speed up printing plates around 4 hours+. each nose cones about 13 hours each plus other bits turned into quite a big print
any other questions ill try to answer
Print Settings
Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Filament_brand:
CC DIY Materials
Filament_material:
PLA
