by jvu4000
A few years ago, someone had gifted me with this statue of the Holy Family. The gift statue was made from a solid block of stone. I wanted something that was smaller and lighter, so I was on a quest to make a 3D model of it. I technically didn't make it. I did some photogrammetry on it and it turned out quite well.
Print Settings
Printer brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.15
Infill:
15-20% it's up to you
Filament_brand:
Sunlu
Filament_color:
White or Marble
Filament_material:
PLA
Notes:
This print will take forever to print, just keep an eye out on it at intervals...
Post-Printing
Use a pair of pliers to break away the supports. Be very careful as to where you grab on to. You can then clean it up with a sharp knife. Again, be extra careful not to damage the print and especially yourself.