This is an updated version of Lloid to include the construction helmet he wears in New Leaf, Pocket Camp, and New Horizons. I also hollowed out the inside so you could conceivably store something in there.
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Filament: Matterhackers, Overture PLA Matterhackers tan, Overture yellow
Notes:
Use your slicer to lay the helmet flat on the printbed. I printed it a few times with various support settings, but could never remove them cleanly (if at all). It ended up printing fine without support, the bottom was just a little messy.
The tolerances are fairly loose, so if you want the helmet to come off easily print both parts at scale. If you want a more snug fit, trying shrinking the helmet down a percent or two. At 100% the fully assembled piece is about 145mm tall.
