by Anonymoose3d
this is the skull splitter from call of duty black ops 3. it's life size and as close to 1:1 as i could get it without proper files. put the pieces together, glue them together and sand it up, paint the pieces and attach it all together. i used a 32" x .5" diameter metal pipe through the middle to give it some rigidity and weight.
use supports everywhere, I use 5-10% infil, and orient the parts so you have to use the least amount of supports. To print the blade parts, lay them flat, and if your print bed is big enough, print the top part and bottom part together on the print bed and orient them the same way, so when you put them together they are uniform, not one part printed on a different side.
if you need any help or advice, just ask
you'll need to print 4x Big Connectors, 3x little connectors, 6x blades
