Kyber Crystal designed to replicate the ones you can buy from Savi's Workshop in Disney's Galaxy's Edge. Printed hollow so you can put things inside if desired (like a RFID chip or LED earing). Top snaps into the main bottom piece.
If you hold a Savi's workshop kyber crystal near this one when you insert this replacement then it should light up like normal for a few minutes.
Printer Brand:
XYZprinting
Printer:
da Vinci Jr. 1.0 Pro
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
100%
Filament: XYZPrinting PLA
Notes:
Rotate so the long side is parallel with the print bed. Rotate so the pointy ends are facing up. I found my print quality was much better if I increased the model size by 10%.
File the bottom tip to round it off.