by rucker
This is a remix of a model by DigitalTargeter with some improvements:
Wheel and tire are separate parts
Added a propeller hub
Propeller is now spinnable when attached to hub via 1.6mm wire (also used for the landing gear axle)
Engine cowling has been redesigned to better resemble its real-life counterpart
Redesigned cockpit with pilot's seat and a separate rim to represent historical leather cockpit lip
Vertical stabilizer design has been altered to add more detail:
Rudder is now a separate part
Lower section of the vertical stabilizer added to the bottom of the fuselage
Tail skid added
RFC markings available:
A large roundel for the wings
A small roundel for the fuselage
A "fin flash" for the rudder
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Filament: AmazonBasics PLA
