by f1lthypawz
Designed in ZBrush and printed on a CR10S4.
Roughly 4mm thick
Used S3D for slicer and printed upright.
Support was 4mm and 45deg angle.
3 Outline perimeter shells
Can print on raft and without.
Temps may be different for you, depending on filament used
Bed at 60
Extruder at 210
SIZE in mm and inch (resize in slicer if needed)
X: 165.10mm - 6.5 inch
Y: 116.11mm - 4.5 inch
Z: 144.23 mm - 5.6
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
Printed at both .15 and .2
Infill:
15%
Filament: Zyltech PLA Black
