by Whirrledpeas
Remix of Fillenium Malcon with Landing Gear deployed. Created an additional rocket booster on back-end of ship to flare-out the base when printing vertical. This reduces the likelihood of tipping over when printing. Also improved the back end model design so it looks better when breaking free from the raft. Put the original round satellite dish back on and beefed up the thickness and bracket so it prints nicely and does not break off when your kids bite it :) Added a round support cylinder between the four canons (both top and bottom guns) so they no longer break off. Redesigned the cockpit window frame so it is not so stringy and thus requires less post-production cleaning. Cleaned up some of the holes in the design but it still takes about 4 minutes for the slicing software to repair the model. Takes about 7 hours on standard/normal quality (.15mm) to print this size (140mm x 100mm x 35mm). 13 hrs at High Quality but the standard quality is really quite good. I prefer the silver filament but gray is nice too. I will also upload a version with an ornament ring to hang on your tree or from the ceiling with fishing line. I will also upload another version with a built in bottle opener which is really cool. Thanks again to aaskedall for sharing this model. Merry Christmas and may the force be with you! Peace on Earth.
Printer Brand:
FlashForge
Printer:
Rafts:
Yes
Supports:
No
Resolution:
.15 mm
Infill:
15%
Filament: 3d Solutech or Hatchbox (gray) PLA 1.75 Silver
