by Ghukek
This is one of my free models, the USS Indiana. The South Dakota class model was my first design from back in May 2018, though this is a modified and updated version of it.
I'll be putting the rest of my free models up here over time, but in the meantime you can find them on my website.
Print at 150% for 1/1200 scale and 75% for 1/2400 scale. 1/1200 comes out very nice but I recommend trying 1/2400 with a resin printer for best results.
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Yes
Supports:
Yes
Resolution:
100 microns
Infill:
30%
Filament: Hatchbox PLA Grey
Notes:
Take care to have a properly calibrated printer for best results. Use very high support angle, such as 75%. Over-use of supports will make for a painful cleanup. For this particular model I only use supports under the aft main guns; everything else prints quite well without supports. You can also use supports under the 5-inch DP secondaries.