by Artrex
I took a photo from the truck reveal and modeled 90% of the truck as it is shown so everything should match as far as body lines go. Deviations can be found elsewhere such as the bumpers and wheels.
I personally printed the version with two separate pieces and superglued them together (feel free to use the pins), but I'm sure it can be printed flat up with a raft as well.
Feedback appreciated
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: Eryone PLA Silver SIlk
Notes:
Support is from bed
I personally superglued the 2 pieces together, but you can also the pins provided.
Wheels and pins worked fine for me, if tolerancing is too little for you (shouldn't be as it was generous), use a heat gun
