by Vijit
This a remix of a great thing made by Mag-net:
the model is 20% smaller.
Cut off the arm at the elbow, so less supports to print full length. It reduced a lot of printing time.
To forearm attached a hand, to immediately, as one model print out.
You'll need to add supports based on your own opinion. I printed with PLA and supported only the shoulder in the main model part.
Note: Thingiverse still makes ugly previews without saving proportions. See the originals for better experience.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
nozzle 0.4, layer 0.15
Infill:
20%
Filament: Greg PLA black
Painting
I used a different acrylic paints: glossy black for dress, metallic black for mantle, raspberry matt as a blood, "flesh" matt color for bones and pearl blue for eyes. No lacquers cause it turned too complicated to make the glossy dress at the same time with a matt blood.
