by Graxxus
Custom Salt and Pepper shakers made to replace cheapo, non-refillables we've had for years. I had to print in pieces to avoid having supports inside that could not be removed. Holes should be big enough for standard table salt and black pepper.
The 6x 2mm holes are for aligning. Cut some 1.75mm filament into ~3mm pieces for each hole to keep backing perfectly aligned when gluing.
The closure fits very tightly on my prints, so if you want it to be refillable, you may want to file it down a tiny bit for easier sliding out. (Not so much it falls out all the time!)
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
15%
Notes:
Supports are only needed in the slotted opening.
Glue backing to body.
The 6x 2mm holes are for aligning. Cut some 1.75mm filament into ~3mm pieces for each hole to keep backing perfectly aligned when gluing.
The closure fits very tightly on my prints, so if you want it to be refillable, you may want to file it down a tiny bit for easier sliding out. (Not so much it falls out all the time!)
