by mmakaj, published
This is a clan Ventrue amulet (but you allready know that ;) ) based on the Vampire the masquerade title. I'm sure there are some fans here ;)
The model was printed on a FDM machine and simplify3d and it prints great.
I recommend printing at 0.1 mm, but can go lower or higher if desired, no problem there.
No supports.
The model is a bit larger so you can scale it as you see fit. I used 25% or 30% in simplify3D.
Looking forward to seing your prints ;)
Printer: Rostock modified
Rafts: Doesn't Matter
Supports: No
Resolution: 0.1
Infill: 20 %
Notes:
use 20% infill and at least 6 - 8 top layers if printing on 0.1 to get good top finish
