by FrankyDLP

My son wanted a Bape Bear, they are pretty expensive for what they are, so I modeled this with that in mind. It was acceptable to him so now he keeps it on his desk. First sculpted model the lines are pretty simple but i believe it is symentrical.

Both files are included if you want to try to print as one piece, or seperately to make easier to print. Use supports as needed.

Print Settings

Printer Brand:                          

Creality

Printer:                          

Ender 3

Rafts:                          

No

Supports:                          

Yes

Filament:                                            Worksteel PLA                                        Red                                        

Notes:

I did this a few months ago so i dont remember the parameters. I know that I kept failing to be able to print it as a whole, so i went back into model and printed it in 3 seperate pieces, thinking i was going to make them magnetic so you would have the abilty to switch pieces with other colors or accessorize. Which I may go back to one day, Instead i just welded pieces together with Soldering pen and Heat gun.

Post-Printing

If you look closely you may see a weld line down his middle. I did thta witl a soldering pen, then smothed a bit with a heat gun. The top and bottom halves were put together by heating the ends with heat gun first and pressing together, the touch up with soldering pen, then again some smothing with heat gun. There is probably a better way and suggestions will be apreciated.