by Hannemaster, published
This is Kerrigan from Starcraft / Heroes of the storm
I made one with a stand and one without. Haven't tried to print yet. Will try as soon as I can and upload pics and info.
Not sure if I should cut it into pieces. My lazy side says: just print it with lotta supports, my smart side says cut it to pieces. but my lazy side wins most of the time xD. If I do cut it and successfully print then I'll upload the pieces.
Follow me to get updates on new uploads! Likes and comments are appreciated!
I usually print these models with settings: 0.2mm quality and 15% infill.
