by Enginecrafter77

This is basically a smoothened version of this thing without the pedestal (Which was scrambled after smoothening).

In the photo you can see his fingers snapped off. This was an accident during removal of support structures. More on this below.

Print Settings

Printer Brand:                          

Anet

Printer:                          

A8

Rafts:                          

Doesn't Matter

Supports:                          

Yes

Resolution:                          

0.1mm

Infill:                          

>20% recommended

Filament:                                            Gembird Polylactic acid (PLA)                                        White                                        

Notes:

It is highly recommended to use soluble support structures if you want to achieve best result.
If your printer doesn't have dual extruder, try rotating the model in the slicer to find the best settings.

Post-Printing

Removing the supports

Removing the supports is very tricky in this model, bacuse it features very fragile and thin parts like the fingers or the neck. When removing the supports around his neck and arms, be especially careful or you will end up with ruined 8 hour print.

I printed him standing vertically with tree supports. The supports were very tricky to remove.

How I Designed This

Meshlab

I used butterfly subdivision function to smoothen the original model and then I removed the pedestal.