by Crafter1542
This is the Devil You Know handcannon from the original Destiny. I modeled this from one somewhat blurry picture, so I apologize for any major inaccuracies. It is 12 inches long, and as you can see from the pictures, it is a beast to handle. If you have any suggestions of what I should model next, leave those in the comments, and I may get around to them. If you loved this model leave a like, and if you hated it, make sure you leave a like.
Printer Brand:
TEVO
Printer:
Resolution:
I printed this at .2, but it should look better with smaller resolutions
Infill:
5-20%
Notes:
The body is best printed upside down, with custom supports on the hammer and not on the area surrounding it. None of the other pieces need supports, and they will all print best standing on end. I was not able to put registration holes in this one due to my terrible modeling skills, but as long as the actual barrel part lines up with the top part of the body, it will be lined up
This will probably require some filler in the handle seam and the barrel seam, but the rest of the pieces should be sanded before glueing, not after. I learned that the hard way.