by Efteling
This is an updated version from my first design. There were a few adjustments needed but my job as a builder @Ultimaker made me to wait for some free time to do that.
But here is Link again! Every part had a small update and some adjustments.
For easy assembly: First the base, then part 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13 and then part 14.
Printer Brand:
Ultimaker
Printer:
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
20% or higher
Notes:
Only part 5 and part 6 need supports.
The base has a support beam.
If the base doesn't fit into the holes of the parts, just sand down the pole a bit.
