by alaskanalain
I love the food tubes but after a short time the bottom splits, spilling what ever you decided to put in the tube. I have had around 6 of the things, all with the same problem, don't even try to use the original.
This is a tight fit but it's also very secure. you could use a bit of warm water to get them on and off easier.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2 or .3
Infill:
100
Filament: doesntmatter PetG
Notes:
Any filament should work.
Print upright, make sure you have good bed adhesion.
