by Heref
This is a Panther tank model at 1:200 scale. This model has a snap in turret, i.e. after printing and cleanup just slowly push in the turret into the hull. It will snap in place and won't fall out.
It is based on m_bergman's excellent model from his 1:100 scale pack. The snap in joint is derived from the clone trooper model by danzca6 .
Print the turret as is for a better quality barrel. Print with the barrel pointing to the sky for less clean up and a stronger snap in joint.
Printed on the M3D micro.
Printer:
M3D Micro
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
200 microns
Notes:
Be sure to clean out the supports between the snaps.
For a better resolution gun, print the turret parallel to the print bed.
For a quicker turret clean up, print with the gun pointing skyward. However, make sure your backlash is dialed in well and use a raft, or the gun may look all crooked.
