by DirtyCake
A 3d scan of an owl statue I had standing on my shelf.
Easy to print if you add supports:
-under the beak
-under the eyeballs
-the underside of the hat.
Resolution is not important and 15% infill worked for me but I think u can go lower.
I will add pictures of where I added supports in S3D.
The file is big because I was too lazy to reduce the resolution after scanning :)
Printer:
Zonestar D805S
Rafts:
No
Supports:
Yes
Resolution:
0.25
Infill:
15%
Filament: Generic PLA Wood
Notes:
200C
