by BobaMaker
Hey everyone!
Check out the video i made for it: https://youtu.be/8iVJ-PJPwXc
This is my ballistic Fist from Fallout New Vegas/3. I really put my heart into this one, it's super accurate and hope you enjoy. If you make one do post it below, it makes my day! every time!
TO PRINT:
-Firstly, ensure you can fit your hand through a 9cm hole. if not, scale it appropriately.
-At native scale, the tallest piece is 17.5cm tall, so make sure your printer can do that.
-you will only need 2 other materials
-Wires (watch the video) that are 8mm in diameter or smaller, I used regular old HDMI cables
-'Leather' straps, 2cm or less in width, for the fist plate
-either follow my video and use sponges or come up with your own way of securing it on your arm.
-I used less than half a roll of filament
-Took about 24 hours in total
Please do not sell this.
