by Scoogs
Just a quick re-work of the awesome Cactuar model by KitenMitens. Found it a little cumbersome and not exactly perfect to glue the two halves together, so I added holes to each half and dowels to snap them together. The scale of the model is out of whack, so you can re-scale to your liking. I didn't re-work and re-scale the existing stand so it's not included.
Print both halves flat side down. No supports or rafts needed. Can print at 10% infill. .15
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.15 or 0.2
Infill:
10%