by neil3dprints

The Batmobile from the Animated Series.  I always loved this design in the animated series.  It had such a sleek and intimidating look to it and was always one of my favourites from all the films and series.  So here you are.  The assemble is simple.
All the parts should pop into place.  A little glue will be required for the assemble, especially for the small exhausts.
If you decide to print please refer MISC notes for further details on how to print.
The Grill Plate requires a colour change at 0.95 from black to grey.
And here are two choices of wheels to use.  There is a design which incorporates 608 bearings for a smooth roll.  And another design for those of you which would prefer the wheel design from the Animated Series.

Happy printing all.

Print Settings

Printer Brand:                          

MK3

Printer:                          

Prusa i3

Rafts:                          

No

Supports:                          

Yes

Resolution:                          

0.15

Infill:                          

30

Filament:                                            Ice Filaments, Prima Select PLA                                        Black, Grey, Yellow                                        

Notes:

The Grill Plate requires a colour change at 0.95 from black to grey.
There are two choices of the wheels to choose from.

1. Incorporates 608 bearings for a smooth roll.

2. Stays true to the animated series wheel design.
   The choice is yours.

I also scaled down the small exhausts to 90%, which is the file shared here.  I found it much easier to print smaller and glue these parts in.  But you may decide to scale these back to 100% and slot these into place.  I just found it too finicky to do this.

Happy printing all.