by remy561
Removed the base plate of the original model.
Recommended settings:
Print with a 5mm brim or raft to keep the hooves in place.
Enable support.
Check support of the front hoof, for me it was well supported with a zigzag support pattern, but not with others.
In my case, CURA generated support in front of one eye and on top of the tail. I removed both they this will not stick to the model.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Yes
Resolution:
0.15mm
Infill:
20%
Notes:
Print with a brim or raft. Make sure front hoof is well supported or it might be pushed away by the printer.