by tommylegba
I took Julien_DaCosta's "Moai statue -No overhang" model and remixed it by running it through the Voronator website (https://www.voronator.com/). This is the result. There were two files produced by the website, the normal and the "simplified" version. What I printed and photographed was the simplified version. I haven't yet tested the "normal" version.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
20% gyroid
Filament: 3D Solutech PLA Natural Translucent