by lowboydrvr
Printer Brand:
Prusa
Printer:
i3 MK3 MMU 2
Rafts:
No
Resolution:
.2mm
Infill:
20%
Filament: Hatchbox/Solutech/Amazonbasics PLA White/Real Black/Aqua Blue/Copper/Red
Notes:
I used 5 colors:
White (Hatchbox) - Dog house, Snoopy's body and snout
Black (Solutech Real Black) - Dog house lettering and door, Snoopy's nose and eye pieces
Red (Amazonbasics) - Dog house roof and Snoopy's scarf
Blue (Solutech Aqua Blue)- Snoopy's hat
Copper (Hatchbox) - Googles, L&R Ear pieces
Here were my print times (total - 27 hours, 35 minutes):
Dog House base - 10 hours, 10 minutes
Dog House plug - 28 minutes
Dog House roof - 8 hours, 7 minutes
All black pieces - 49 minutes
All copper pieces - 1 hour, 5 minutes
Snoopy's body - 3 hours, 3 minutes
Snoopy's snout - 1 hour, 3 minutes
Snoopy's hat - 2 hours, 10 minutes
Snoopy's scarf - 40 minutes
Supports were only used for:
Dog House base (where plug goes)
Snoopy's googles (or copper pieces if you print all of them at once)
Snoopy-s body (I printed at an angle to get the best results)
