by killminusnine

This is the mythic Ford Mustang Shelby GT500 PP 1967.
I wanted to offer a version with door windows opened to reveal a lot of indoor details. The bottom of the car is very detailed too. The problem is that this model is very hard to print and to remove printing supports without breaking thin parts.

I think I will design a simpler version with door windows closed and without any details below.

Warning ! If you doesn't want to waste PLA on multiple attempts, don't print this model. It is still work in progress. To print it easily, you may reduce scale to fuse details into the main body of the vehicle.

Print Settings

Printer Brand:                          

RepRap

Printer:                          

RepRap Ord Bot Hadron

Rafts:                          

Yes

Supports:                          

Yes

Resolution:                          

0.3

Infill:                          

50%

Filament:                                            Amazon PLA                                                                                

Notes:

This model is still in WIP status because of the sharp details indoor very hard to print. So, infill must be greater or equal than 50% to harden small parts and main parts. It will be easier to remove the printing support without breaking them. I think I will design a new version with door windows closed to remove indoor details.