by kendel3d

This is a remix of Hyo Jung's Cute Bulldog decoration.  I turned it into a bookmark, which is perfect for this model!  It looks like it's looking over the top of the book.  Very cute!  Check out Hyo Jung's many other designs, she is very talented.

There are two versions of this bookmark, a regular one and a thin one.  The regular one is the same thickness at Hyo Jung's original model and the thin one is just 1mm thick.

The thicker one should be printed with 3 solid bottom layers with about 15% infill and 5 top solid layers.  It is about 3.7mm thick.  Print the thin one solid.

Print Settings

Printer:                          

Go Big 3D Genesis 8

Rafts:                          

No

Supports:                          

No

Resolution:                          

0.4mm nozzle, 0.2mm layer height

Infill:                          

15-100%

Filament:                     Atomic Filament PLA or PETG                                        Yellow                                        

Notes:

This model is best printed with a 0.4mm nozzle or smaller.  PLA or PETG would work.  The lower part is thin enough that both plastics will be flexible.  PETG is a little tougher and more flexible though.  To print with PETG, the hotend should be 240 and the printbed should be 75C.