by daddyDagon

kirishima's daggers from my hero academia's "fantasy au."

modeled based on the (rather limited) pieces of official art. note that these are sized for a 6'1'' guy and measure ~26.5'' at default size, so some resizing may be necessary.

estimated print time: ~13 hours (i suggest using a raft to ensure the seams are as flush as possible)

support: there's a hole running through all the pieces big enough to snugly fit 3/8'' dowel, such as you might find at any old hardware store.

warning: depending on your printer, the tolerance of the dowel hole can get pretty tight. if you can't work the dowel through the longer portions of the blade, a good alternative is to cut the dowel rod into sections and stick as much as you can into each piece of the sword.

if you're planning to bring this to a con, make sure to sand the tip down, as it's painfully pointy fresh off the printer.

Print Settings

Printer Brand:                          

Creality

Printer:                          

CR-10

Rafts:                          

Yes

Supports:                          

Yes

Resolution:                          

0.25 mm

Infill:                          

10%

Notes:

nozzle 0.4mm, wall thickness 0.8mm, wall line count 2