by hellra1ser
Nice work done by lonewolf011, thank you!
I modified the mesh and did a bit more slicing:
base socket modified:
removed the alignment stuff (?)
added 2mm to the bottom to look better when it stands on a surface
made bottom concave
head section:
cura slicer ran amok when slicing the original model, so I cleaned up the head inner part
Printer:
Extremely pimped RRP Mendel
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.15 or 0.20
Infill:
15%
Prepare pieces
sand the bottom surfaces (and top surfaces of the lower pieces).
also sand the outer faces to look how you want.
Glue together
Stack/orient the pieces to match the preview STL, then glue 'em together.
I print my parts in ABS, so I prefer ABS+Acetone as glue.