by AprilStorm
Still very much a work in progress. Will be updated over the next few weeks as model is finalised. I managed to print one full blaster, but believe I can separate the parts better, also the stock is a little off.
Also, as a warning, some parts may not be 100% correct scale, so check before printing.
This is a complicated multipart build. I would really only recommend printing in ABS as it depends on the ability to glue/weld several parts together.
Please Note: This model is largely based on work done by Charles D. Rhodes and was used with permission to create props that can be used by charitable organisations like the 501st Legion and the Mandalorian Mercs. The model has since been heavily modified to make it practical to print on a 3D printer, there have also been structural simplifications as well as changes to some components to bring it into line with prop standard for these clubs.
