by zomeow, published
My first 3D model is a towel hanger created with some very much appreciated help. Original size was 24 cm wide (x) but could not export it like that so you'll have to scale it up.
GET goes on the wall while the letters of Naked are holding the towels. There are holes in the back so that you can either stick it to a surface or use the little holes in the back to hang the design on screws.
Support is needed but the MakerBot Replicator I used added very little support structure to the model. Best to print in 2 colors changing right after the top surface of GET gets closed.
Printer Brand: MakerBot
Printer: MakerBot Replicator
Rafts: Yes
Supports: Yes
Resolution: 0,2
Infill: 20%
Notes:
I've printed it with 3 shells and 20% infill to get a strong object - I hope it's gonna endure the life of a not-so-tortured towel hanger in my flat. :)