by gangel99
The flower was put on the plate just as shown in the photos. There is very little of the flower and leaf that touches the plate so you need support. I have done a number of these in different sizes and found that a either a raft or a brim will work on my printer which has a heated glass plate.
The Cura 3.4 settings were Resolution: 0.2mm, Infill 12% Support 'Touching Build' and a Support Angle of 70 degrees.
Printer Brand:
TEVO
Printer:
Rafts:
Yes
Supports:
Yes
Resolution:
.2 mm
Infill:
12%
I first tried using a 3D scanner with flowers from my garden but it turns out the Calla Lily is very complex. Then I hired Agastin Brando via Upwork.Com and he took my photos, redid them in Zbrush and sent me an .STL file which I modified in MexhMixer and MudBox.
