I felt the board was just a bit overwhelming for someone not familiar with Pokemon.
So hey, a remix!
Mirrored Rooks, and a small flat space on Arbok's back which lines up with the flat on the base. It actually prints pretty well without supports.
Pikachu does well without too.
I solidified under Bulbasaur so should print well.
Haven't finished printing the whole thing yet so may upload edits as they happen for solidness and easier printing.
Seadra was a major pain, I also edited Horsea to have the flat of the base towards his back and lengthened his spinal fin to make contact as well but will still need supports for the spines. (Will upload with built in supports if anyones interested.)
Will definitely be updating charmander and the Nidos but no time tonight.
Sizes are scaled for a tournament board which is 2.25"x2.25" per square.
Heights don't quite work out right but diameters do.
Many, many thanks to sch00f for an awesome set of originals!
