This is a remix of xnielsda1's files, I took them scaled them up for the sword to measure ~4.5ft in length as well as added cavities for a support dowel in the handle leading into the first 2 parts and for 2 support rods down the length of the sword. Minor touch ups on some of the pieces to remove some artifacting was also done.
Printer:
AM8
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
10%
Notes:
All pieces were printed at 10% infill with the exception of Bottom 8 and Top 8, those were printed at 25% to allow for a stronger point of support for the dowel.