Beware of the fearsome Rathalos. This is Rathalos from the games series Monster Hunter. This model does a tail that can be removed. I figured it would be great in d20 games. A while back I uploaded a Rathalos that needed some work. Well that work is now done. I have learned a few more skills and here is the results.
I started with a gamerip from Monster Hunter Tri, from there I ran through makeprintable.com to make a water tight mesh. Then I posed it in Blender, that probably took the most time. Next, I sliced it up in meshmixer to reduce supports and make it easier to print. I included a whole model in the downloads as well.
To print I recommend turning on "print thin walls" and "horizontal expansion" us a multiple of your nozzle for the horizontal expansion, like 0.4mm 0.8mm 1.2mm. You will need supports, with the cut parts, the amount of supports are drastically reduced. you will also need to scale the tail pin smaller than the rest of the parts. I scale the tail pin to 1300%, the base 200% and the rest 1500%. This makes it gargantuan size in DnD, Pathfinder, or 28mm scale. I printed with a Alunar m505, Dazzle Light white Pla, 0.12 layer height, 200c nozzle temp, 0.4 nozzle, speed of 50 mm. I hope ya'll like.
For DnD 5e stats go here https://www.reddit.com/r/DnD/comments/86bl8s/5eochomebrew144_page_monster_hunter_series/
