Edit: The Crown had a wrong normal, should be fixed now.
For my first 'big' project, i decided to tackle Star Butterfly's first wand.
Simple design, did it on pieces so I could print it a bit bigger.
From scratch, made on Blender.
Had to re-do the crown, did it "flat" the first time, later on I found a better ref for it.
Haven't printed the last version yet!
(Full_Wand is there only so you can see the finished idea =P)
Printed them at 0.2 layer, 15% infill.
Rod and body need supports, the rest prints without them.
Print one of each piece, and two of the wings (flip one~!)
