A recreation of the Hufflepuff Cup from Harry Potter.
Modelled in Silo then detailed in Sculptris. I suggest using vapour smoothing or XTC 3D rather than sanding to finish.
Printer Brand:
FlashForge
Printer:
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
100%
Notes:
The base prints as one piece easily and the handles can be reproduced flat on the print bed. The cup itself is problematic. You can print it in two halves either vertically or horizontally without supports. As one piece I suspect it will need some support. I'll leave it up to you which you prefer.
I printed this in sections but an SLA printer should be able to print the whole thing in one piece (and do a fine job of it too).