by ClassyGoat, published
This print was a bit tricky and required a whole lot of supports that were a pain in the Ash to remove. If you can figure out a way to do it with far less supports, I would be delighted to see.
I printed this on a FlashForge Creator 1 (based off of the Replicator 1)
I used grey ABS and sliced with these settings:
3 layer thick raft.
Full Support (YOU MUST USE SUPPORTS WITH THIS MODEL!)
10% Infill
0.2 mm Layer height
3 Shells
40 mm/s feedrate
75 Travel feedrate
230 degree temperature.
It took roughly 4 and a half hours to print.
