I made the entire castle smaller because it was annoying to scale it down to such a small size. Also because I wanted to print it out on my MP Select Mini V2. The base is also reduced on the sides as I found it to be a waste of space.
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
May need to scale it up
Infill:
30-50% might be good.
Notes:
Support extra note: You might need support if you want some details to show up well.
Infill must be high if you are printing this as the base of the print will be hollow which will lead to the sides of the towers not coming out properly.
