I designed this wand for my wife, who is a huge Harry Potter fan. (She's a Slytherin)
Designed using a spline and "Lathe" tool, then customized further afterward.
Michelle_Wand_OnePiece: The full-size wand (9.1", 232mm - most printers don't have this build volume, but if yours does, this is the preferred way to print)
Michelle_Wand_Split: The wand, split in half (tip and base) with a built-in tapered connector peg for easy gluing. Build volume of the split model is 147mm x 31mm x 17mm.
Michelle_Wand_Base: Just the base
Michelle_Wand_Tip: Just the tip
Rafts:
Doesn't Matter
Supports:
Yes
Notes:
It's recommended to print this on its side for stability reasons, and also because the print layers will have a wood grain effect once finished, making it look much nicer than a vertical print.
The connection joint has a little bit of wiggle room which should ensure a snug fit if coated with the right amount of glue or epoxy.
